Show some recent work
Out of context: Reply #7204
- Started
- Last post
- 8,719 Responses
- GeorgesII3
Incoming wall of text
TLDR: I made a 3D printed cross and put it up inside an art and technology event inside a church.
-
The project is called Sinbot. It was a chatbot priest which you could access through the mac which would then send data to my piece on the wall and update the leds.
but... There was no internet connection so I had to fall back on the non lOT part.
The animations where divided in two categories.
You: Webcam activated animation where the cross act like a mirror and you are inside it.
Silence: The microphone picks up ambient sounds and send animations to the cross.
Most of this project was printed on my Cr8 but two of the panels where done on the Taz5.
The Leds are in a 8x8 matrix format and driven by a single Fadecandy. You can't really see it but there's also a distance sensor running on an arduino uno which alternated the tints depending on how close you were from the cross.
This project was made from scratch in 3 weeks,
last prototype test
