Indesign bleed question.
Indesign bleed question.
- Started
- Last post
- 4 Responses
- grymes
Say you are creating a book bound by wire-o and on one of the spread you want a full bleed imagine that would be printed on 11x17 and cut down to size. It needs to bleed to the center as well. So you set your frame to bleed but then it's also going to be printed on that facing page. Something I don't want. How do you bleed to center one side of the spread and keep it from affecting the other?
- duckofrubber0
Don't print full spreads. Why would you anyway if you are wire-o binding?
- +1alicetheblue
- Sometimes you're limited to the resources available/allowed and I'm just trying to make the most of it.grymes
- ian000
deign it in full spreads. then break it up into single pages and pull out bleeds before printing.
- Bingo.duckofrubber
- Definitely the more obvious solution, I was just curious to know if InDesign had this option built in.grymes
- hiimerik0
+1 for ian00
- ian000
make sure you get the facing right. (assuming it's double sided.)